0,00 RON 0

Senzor intrerupator bataie palme, ICSK050A (Kit)

Imaginile produselor au caracter informativ si pot prezenta diferente minore, in functie de lot si de furnizor. Este posibil ca specificatiile si pretul produselor sa fie modificate fara preaviz. Facem tot posibilul sa adaugam in pagina produselor specificatii cat mai exacte si corecte dar este posibil ca acestea sa nu fie in totalitate corecte. in cazul in care identificati un astfel de caz, va rugam sa ne semnalati acest lucru.

Produsul este destinat specialistilor si necesita personal calificat si autorizat. Produsul nu include instructiuni de asamblare/utilizare. Punerea in functiune a produsului de catre persoane necalificate duce la pierderea garantiei conform Termenilor si Conditiilor din site.

Senzor intrerupator bataie palme, ICSK050A (Kit)

17,85 RON

cu TVA inclus

Citeste 3 review-uri

Scor mediu 4/5 Numar review-uri 3

Adauga la favorite

Trebuie sa te autentifici

Autentificare | Cont nou

Primeste o notificare prin e-mail atunci cand acest produs devine disponibil

Cererea ta a fost inregistrata cu succes. Vei primi un mail in momentul revenirii produsului in stoc.

LIVRARE GRATUITA

Adauga in cos produse in valoare de 120 Ron

EXPEDIERE RAPIDA

Expediere din stoc in 24H

DISCOUNT 5%

La toate comenzile minim 500 Ron

Intrerupator cu senzor bataie palme ICSK050A sub forma de kit.

Tensiune alimentare: 5VDC

NOTA: a se adauga jumper precum in poza nr.3

Circuit description: This circuit is mainly composed of audio amplifier circuit and bistable trigger circuit. Q1 and Q2 constitute the two stage audio amplification circuit. The audio signal received by MIC is coupled to the base of Q1 by C1. After amplification, it is directly fed to the base of Q2 by collector, and a negative square wave is collected at the collector of Q2, which is used to trigger bistable circuit. R1 and C1 limit the frequency response of the circuit to a high sensitivity around 3kHz. When the power is turned on, the state of the bistable circuit is Q4 cut-off, Q3 saturation, and LED1 not bright. When MIC receives the control signal, it outputs a negative square wave after two stages of amplification. After differential processing, the negative point pulse is added to the base of Q3 through D1, which makes the circuit Flip quickly and LED is lighted. When MIC receives the control signal again, the circuit turns over again and the LED is extinguished. If the LED lamp circuit is connected with other circuits, the sound control of other circuits can be realized by J2.