The images of the products are informative and may show minor differences, depending on the batch and the supplier. It is possible that the specifications and the price of the products can be changed without notice. We do our best to add the most accurate and correct specifications to the product page, but it is possible that they are not completely correct. if you identify such a case, please report this to us.
The product is intended for specialists and requires qualified and authorized personnel. The product does not include assembly/use instructions . Putting the product into operation by unqualified persons leads to the loss of the warranty according to the Terms and Conditions on the website.
Panel programmable delay relay, 12V, with display, T3230
International fast shipping within EU. Free Shipping for orders above 100 EUR in most EU countries.
We ship from our stock within 24H
All orders minimum 100€
Programmable delay relay module (timer) with display and panel mounting. This module can be programmed in multiple configurations that require the configuration of the actuation times. The display shows the two times (T1 and T2) through the two displays. It has buttons for accessing the menu (UP, SET, DOWN and RESTART).
Pins S1 and S0 act as a switch (On/Off).
Specifications:
Supply voltage: 12VDC
Model: T3230
Functions: Timer, Delay, Cycle
Relay: 20A
Maximum current: 10A
Maximum voltage: 220VAC
Maximum power: 500W
Dimensions mm: 79 x 26 x 43mm
Panel cutout dimensions: 72 x 40mm
Settable times: seconds, minutes or hours, between 0 - 999
Time margin of error: 5%
Functions:
Attention: The module needs 6 seconds to memorize the settings.
The module maintains the program in case of power failure.
P0--0: Timing time mode: 0---999s.
P0--1: Timing time mode: 0---999min.
P0--2: Timing time mode: 0---999h.
P1--0: The relay will connect after you delay the T1 time.
P1--1: The relay will disconnect after you delay the T1 time.
P1--2: The relay will connect after you delay the T1 time first, Then the relay will disconnect after you delay the T2 time, it finishes.
P1--3: The relay will disconnect after you delay the T1 time first, Then the relay will connect after you delay the T2 time, it finishes.
P1--4: The relay will connect after you delay the T1 time first, Then the relay will disconnect after you delay the T2 time, it is cyclic.
P1--5: The relay will disconnect after you delay the T1 time first, Then the relay will connect after you delay the T2 time, it cyclic.